Campaign | unicaACOOptAdmin
These configuration properties define settings for the unicaACOOptAdmin tool.
getProgressCmd
- Description
Specifies a value that is used internally. Do not change this value.
- Default value
optimize/ext_optimizeSessionProgress.do
- Valid Values
optimize/ext_optimizeSessionProgress.do
runSessionCmd
- Description
Specifies a value that is used internally. Do not change this value.
- Default value
optimize/ext_runOptimizeSession.do
- Valid Values
optimize/ext_runOptimizeSession.do
loggingLevels
- Description
The loggingLevels property controls the amount of detail that is written to the log file for the Contact Optimization command-line tool, which is based on severity. Available levels are LOW, MEDIUM, HIGH, and ALL, with LOW providing the least detail (that is, only the most severe messages are written). The ALL level includes trace messages and is intended primarily for diagnostic purposes.
- Default value
HIGH
- Valid Values
LOW | MEDIUM | HIGH | ALL
cancelSessionCmd
- Description
Specifies a value that is used internally. Do not change this value.
- Default value
optimize/ext_stopOptimizeSessionRun.do
- Valid Values
optimize/ext_stopOptimizeSessionRun.do
logoutCmd
- Description
Specifies a value that is used internally. Do not change this value.
- Default value
optimize/ext_doLogout.do
- Valid Values
optimize/ext_doLogout.do
getProgressWaitMS
- Description
Set this value to the number (integer) of milliseconds between two successive polls to the web application to get progress information. This value is not used if you do not set getProgressCmd.
- Default value
1000
- Valid Values
An integer greater than zero