Installing the Linux™ target
You can install the target component on a Linux™ computer by using the RPM file that is provided in the BigFix® Remote Control installation files.
Before you begin
Note: The target, CLI, gateway, and broker component
installation packages depend on the 32-bit version of the following libraries. For all components,
glibc and libblkid. Also, for the target component,
libgcc, libXmu, libXtst,
libXp, libXi, libXScrnSaver, and
libXinerama. Therefore, you must ensure that the libraries are installed.
Use the
ibm-trc-target-9.x.x.i386.rpm file to install the target
component in Linux™, where 9.x.x is the version that you want
to install. For more information about how to obtain the Linux™ component installation files, see Obtain the installation files. Choose the appropriate method for obtaining the
file.About this task
Install a default target RPM file and then configure the target after the installation.
To install the RPM file, run the following command and use the file specific to the version that you want to install. For example,
rpm -ivh ibm-trc-target-9.1.4.i386.rpmResults
/etc/ibmtrct.conf
file. For more information about target properties and their
definitions, see Properties that can be set in the target configuration.