Manually editing values

Procedure

  1. In the List editor, click Add.
  2. Enter the value and display value in the available textboxes. If no display value is specified, then the value is used for display in reports.
    • Avoid adding entries that match your dimension constants, such as others and limit, which may cause confusion.
  3. For values that you want to be included in deviations calculations, click the check box in the Track Anomaly Detections column.
    • To track all values in the list for deviation calculations, click Track All.
    • To ignore all values in the list for deviation calculations, click Untrack All.
      Note: Tracking dimensional values for deviation calculations can affect data storage. You should track only the dimensional values that are most meaningful to the accurate computation of the standard deviation of the dimension. For more information about deviations, see Manage Events - Anomaly Detection Tab.
  4. Click Add again.
  5. Repeat the above steps until you specified all values.
    • To remove a value, click the X icon next to it.
    • To remove all values, click Remove All.
  6. To save a draft, click Done.
    Note: Saving a draft saves the item to the session cache on the server. Changes must be committed before they are applied to the incoming session data. See Discover Event Manager.

Results

  • To cancel your new list, click Cancel.