Installing the Linux™ controller
Before you begin
About this task
You can install the controller in two modes in Linux™, a FIPS-compliant controller or a standard controller.
Procedure
Type the relevant command for installing the controller. Where 10.x.x is
relevant to the version that you want to install. .
- For the standard controller type
#rpm -ivh ~/BigFix/Tivoli_Remote_Control/RCTarget/trc-controller-10.x.x.noarch.rpm
- For a FIPS-compliant controller, install the standard controller and the FIPS-compliant JRE
by running both commands.
#rpm -ivh ~/BigFix/Tivoli_Remote_Control/RCTarget/trc-controller-10.x.x.noarch.rpm
#rpm -ivh ~/BigFix/Tivoli_Remote_Control/RCTarget/trc-controller-jre-10.x.x.i386.rpm
Results
Note: Standard controller installations work with the
trc-controller-10.x.x.noarch.rpm file, with an alternative JRE installed on
the system. If the controller is to be FIPS-compliant, the
trc-controller-jre-10.x.x.i386.rpm file must also be installed. The
trc-controller-jre-10.x.x.i386.rpm file can also be installed even if the
controller is not going to be run in FIPS mode.
You can start the controller from your applications list when it is installed.