Installing the CLI tools in Linux™
You can install the CLI tools on a Linux™ computer by using the RPM file that is provided in the Remote Control installation files.
Before you begin
Note: The broker component installation package depends on the 32-bit
version of the following libraries: glibc
libgcc, libblkid, and
libstdc++.
Use the
trc-cli-10.x.x.i386.rpm file to install the CLI tools in
Linux™. Where 10.x.x is relevant to the
version that you want to install. For more
information about obtaining the Linux™ component installation
files, see Install the Remote Control components. Choose the appropriate method for obtaining the
file. About this task
Note: If the trc-target RPM file
is installed, you do not need to install the trc-cli RPM
file because the CLI commands are already included in the target.
For more information about using the commands, see the BigFix® Remote Control Controller User's
Guide.
Procedure
-
Type, the following command to install the command line software.
Where 10.x.x is relevant to the version that you want to install.
$ rpm -ivh ~/BigFix/Tivoli_Remote_Control/RCTarget/trc-cli-10.x.x.i386.rpm
-
When the installation is complete, edit the /etc/trc_target.properties file and set
your configuration.
- Set the value of ServerURL to the host name or IP address of your BigFix® Remote Control Server.
- For FIPS-compliance set the value of FIPSCompliance to Yes.
- For NIST SP800-131a compliance, set the value of SP800131ACompliance to yes.
- Save the file.
Results
For more information about using these commands, see the BigFix® Remote Control Controller User's Guide.