Step 5. Verify subsystem details
Process Options Help
──────────────────────────────────────────────────────────────────────────────
DLI Mode Parameters : Subsystem Selection
Read PSB Region AGNs
Cmd SSID Status Only Types Types Used Description
IFA2 ACTIVE N BOTH BMP N IFA2 - BMP only
IFB2 INACTIVE Y BOTH BOTH N IFB2 - READONLY
IF92 ACTIVE N BOTH BOTH Y IF92 - UAGNS=Y and 3 AGNs
IF82 ACTIVE N BOTH BOTH Y IF82 - UAGNS=Y and no AGNs
IF72 ACTIVE N BOTH BOTH N IF72 - UAGNS=N, READONLY=N
IF62 ACTIVE N BOTH BOTH Y IF62 - UAGNS not spec, 6 AGNs
IF52 ACTIVE N DYN BOTH N IF52 - DYNAMIC, all unprotect
IF42 ACTIVE N STAT BOTH N IF42 - STATIC, all protected
IF32 ACTIVE N BOTH BOTH N IF32 - DYNALLOC=Y
IF22 INACTIVE N BOTH BOTH N IF22 - IMS V7
IF12 ACTIVE Y BOTH BOTH N IF12 - UAGNS=N, READONLY=Y
**** End of data ****
Command ===>
Check that all the subsystems that you specified in the ZDT/IMS installation options module are listed, and that the correct details are listed for each.
Select the subsystem that you are using for the verification process and press Enter. The DLI Mode Parameters panel is displayed.