Starting and stopping the server
The HCL Traveler server and the HTTP server automatically start if you accept the default settings during installation. Use the commands in this topic to manually start or stop the HCL Traveler server.
To start the HCL Traveler server, enter this command on the Domino® Console:
load traveler
To stop the HCL Traveler server, enter one of these commands on the Domino® Console:
tell traveler shutdown
tell traveler quit
shutdown
command waits for any pending
syncs to complete and then quits. The quit
command
does not wait for any pending syncs to complete and quits in a much
shorter amount of time. The default quit time for shutdown is 300
seconds, and 40 seconds for quit. You can override the default shutdown
and quit time by setting the notes.ini
parameters NTS_MAINTASK_SHUTDOWN_WAIT_TIME
and NTS_MAINTASK_QUIT_WAIT_TIME
.
The values are in seconds. To restart the HCL Traveler server, enter this command on the Domino® Console:
restart task traveler
Domino® HTTP server
HCL Traveler requires the Domino® HTTP server to be running. When the HCL Traveler server task starts, it will check to see if the Domino® HTTP server task is running and start the task automatically. This is the recommended operation for a server that is dedicated to running just HCL Traveler, since the HCL Traveler server task will delay the start of HTTP until it is ready to receive requests from mobile devices. If the HTTP server starts right away and mobile devices attempt to connect to the server before the rest of the server tasks begin, then you will see warning messages on the Domino® console indicating that the HCL Traveler task is not yet started and the mobile device request will be denied.
If this
behavior is not desired, it can be disabled by setting NTS_AUTOSTART_HTTP=false
in
the notes.ini
file.
NTS_AUTO_CONFIG=false
to the
notes.ini
file.