Enabling NIST SP800-131A compliance on Linux or UNIX based targets

About this task

After you install the IBM® BigFix® Remote Control target, you can enable NIST SP800-131A compliance by editing the ibmtrct.conf file. To enable NIST SP800-131A compliance, complete the following steps.

Procedure

  1. Edit the /etc/ibmtrct.conf file.
  2. Set the value of SP800131ACompliance to yes and save the file.
  3. Restart the target service.
    For more information about restarting the target service, see Manage the component services. Follow the steps in the section that is relevant to your operating system.