When you select the ended-in-error
list, you can also define a
layout to use for the list. About 90 fields can be displayed in an
ended-in-error list (see Fields displayed in ready and error lists).
Not all of these can be presented at once in the same ended-in-error
list. But you can specify two panels for your layout and switch between
these panels using the LEFT and RIGHT commands. Information on the
fields that are to be displayed, and the order in which they should
be displayed, is kept in a named ended-in-error list layout.
There might be many different layouts in your installation.
If
you have not specified a layout, HCL Workload Automation for Z displays
a list of existing layouts. You can then select a layout from this
list. If you want to change the layout of the ended-in-error list,
enter the name of another layout in the corresponding field in the
ended-in-error list, and HCL Workload Automation for Z will
display the ended-in-error list using the layout you specified. You
can get a list of all the ended-in-error list layouts by entering
an asterisk (*) in the LAYOUT ID field on the SPECIFYING ENDED IN
ERROR LIST CRITERIA panel: Figure 1. EQQMERRP
- Specifying ended in error list criteria
EQQMERRP ---------- SPECIFYING ENDED IN ERROR LIST CRITERIA -------------
Command ===>
Specify selection criteria below and press ENTER to create a list
of operations that have ended in error.
LAYOUT ID ===> OPCESA__ Id of layout, * for a list
JOBNAME ===> ________
APPLICATION ID ===> ________________
OWNER ID ===> ________________
AUTHORITY GROUP ID ===> ________
WORK STATION NAME ===> ____
ERROR CODE ===> ____
GROUP DEFINITION ===> ________________
CLEAN UP TYPE ===> ____ Types list: A M I N or blank
CLEAN UP RESULT ===> _______ Result list: C E or blank
OP. EXTENDED NAME ===> _______________________________________________