Execute the following command to start a backup to tape
without specifying a level: ontape -s
You
can use the -L option to specify the level of the backup as
part of the command, as the following example shows: ontape
-s -L 0
Use
the -d option to avoid interactive prompts when you are backing up
to or restoring from a directory: ontape -s -L 0 -d
When
you do not specify the backup level on the command line, ontape prompts
you to enter it. The following figure illustrates a simple ontape backup
session. Figure 1. Example of a simple backup created with ontape
ontape -s
Please enter the level of archive to be performed (0, 1, or 2) 0
Please mount tape 1 on /dev/rst0 and press Return to continue ...
16:23:13 Checkpoint Completed: duration was 2 seconds
16:23:13 Level 0 Archive started on rootdbs
16:23:30 Archive on rootdbs Completed.
16:23:31 Checkpoint Completed: duration was 0 seconds
Please label this tape as number 1 in the arc tape sequence.
This tape contains the following logical logs:
3
Program over.
The following example shows how to create a level-0 archive
of all storage spaces to standard output, which is diverted to a file
named level_0_archive in the directory /home:
ontape -s -L 0 >/home/level_0_archive -t STDIO
The
following example assumes TAPEDEV STDIO in onconfig and
creates a level-1 archive to standard output , which is diverted to
a pipe:
The compress system
utility reads from the pipe as input, compresses the data, and writes
the data to the file level_1_archive in the /home/compressed directory.
The ontape information messages are sent to stderr.