Home
Basic Job Setup
You configure a job by choosing the settings that best enable AppScan® Enterprise to access your application and run tests on it.
Manual Explore
Manual Explore enables you to focus the scan on specific parts of your application.
Traffic recorder troubleshooting
If your external device is configured correctly, AppScan's external login recorder and external traffic recorder will show the traffic sent from the device as you send it. This section offers suggestions if it does not.

Welcome
Getting Started
Basic Job Setup
You configure a job by choosing the settings that best enable AppScan® Enterprise to access your application and run tests on it.
- URL and Servers
  URL and Servers view of the ADAC.
- Login Management
  Login Management view in Basic Job Setup.
- One-Time Password (OTP)
  If required by your application, configure AppScan® to use OTP when logging in.
- Manual Explore
  Manual Explore enables you to focus the scan on specific parts of your application.
  - Using a browser
    Manual Explore enables you to focus the scan on specific parts of your application.
  - Using an external client
    Manual Explore enables you to focus the scan on specific parts of your web services.
  - External Traffic Recorder
    When you manually explore using AppScan as a recording proxy, this recorder displays domains detected and traffic received, and enables you to control which of these will be tested. A limited version of the recorder is used to record the login sequence.
  - Traffic recorder troubleshooting
    If your external device is configured correctly, AppScan's external login recorder and external traffic recorder will show the traffic sent from the device as you send it. This section offers suggestions if it does not.
- Communication and Proxy
  Communication and Proxy view of AppScan® Dynamic Analysis Client (ADAC).
- HTTP authentication
  Add server-level authentication and client-side certificates, if required by the application.
- Job Properties
  The final stage of the setup is defining Job properties.
Additional Job Setup
AppScan® Enterprise users with additional privileges assigned by the Administrator see Additional setup options below the Basic options in the left pane. Other users do not see these options.
Notices

Traffic recorder troubleshooting

If your external device is configured correctly, AppScan's external login recorder and external traffic recorder will show the traffic sent from the device as you send it. This section offers suggestions if it does not.

Use the following checklists to review possible causes of the poblem

Postman:

Check that Postman is installed. ADAC has been tested with Postman 7.33.x.
Make sure that the following settings are configured in Postman:
- Settings > General tab > SSL Certification must be OFF.
- Settings > Proxy tab > Use system proxy must be ON, and all other settings in that tab should be OFF.
In your OS Settings > Proxy Setting > Manual Proxy Setup, verify that either:
- Use proxy server is OFF, or
- If Use proxy server in ON, verify that:
  - It is configured for AppScan
  - Don't use the proxy server for local addresses check box is not selected

SoapUI:

Check that SoapUI is installed. ADAC has been tested with SoapUI 5.6.0
Verify that no additional instances of SoapUI were open when AppScan opened it.
Note: The configuration changes that AppScan makes when it opens SoapUI (IP and port), affect all instances. It is therefore recommended that no other instances be open when AppScan opens SoapUI, or at any time you are using it with AppScan. When you close AppScan, SoapUI is closed too, and the configuration change is reverted.