Your Sametime® Community
Server will use the IBM® Domino® HTTP server. It
is possible that you may have already configured IBM HTTP Server for IBM i
on your system for other applications. If so, then you must verify
that each instance of the HTTP server is bound to a specific TCP/IP
address. This will prevent it from conflicting with your Sametime server.
About this task
To change the HTTP server settings
using commands, follow these steps:
Procedure
- If the HTTP server is currently running, type the following
command on any IBM i command
line and press Enter to end it:
- Start the HTTP Administration server by typing the following
command and pressing Enter:
STRTCPSVR SERVER(*HTTP) HTTPSVR(*ADMIN)
- Open the IBM HTTP
server configurations page.
- Select a configuration from the menu at the beginning of
the screen, and complete the following items for each configured instance
of the HTTP server:
- In the navigation pane, select General Server Configuration.
- Locate the IP address and port table in the section called Server
IP address and ports to listen on.
- If one of the rows in the table has an asterisk (*) in the IP
Address column, then the server is listening on all IP
addresses. Select that row. Replace the asterisk (*) with the IP address
for this server and click Continue.
- When finished updating the server IP address table, click Apply to
save your changes.
- When each instance of the HTTP server is configured to
use a specific IP address, restart the HTTP servers by typing the
following command and pressing Enter: