Troubleshooting: Create a cluster option
Creating a cluster is part of setting up a clustered environment.If you encounter a failure during the configuration process, determine whether you can run the step again, skip the step, or if you must clean up the step. For some failed steps, learn how to correct the issue and recover from the failure.
Each potential step in the configuration is included. Because the steps vary depending on your selections, the steps are not numbered. Find the step that failed to learn more about correcting and recovering from the failure. If you need to change a value that you entered in the wizard, then you must run the configuration again.
Manual Step: Verify that the portal node and deployment manager system clocks are within 5 minutes of each other
Manual step errors occur outside the context of the wizard.
About this task
Actions | Notes |
---|---|
Run the step again | Not applicable |
Skip the step | If you successfully completed the step before, then skip this step. |
Clean up step | None required |
Federate the node
When you federate the node, it becomes a managed node in the deployment manager cell.
About this task
If this step fails see the addNode.log to determine why the step failed. In most cases, you can correct the error condition and run the step again. You do not have to cancel or reset the configuration steps.
The log is in the /wp_profile/logs directory
Actions | Notes |
---|---|
Run the step again | If the step did not complete successfully during the previous configuration, run it again. |
Skip the step | If you successfully completed the step before, then skip this step. |
Clean up step | Based on where the step failed
during the addNode task, you might need to remove
the node and run the step again. Run the removeNode command
from the wp_profile/bin directory. Example:
|
Configure the dynamic cluster node
Applies to dynamic clusters only.
About this task
Actions | Notes |
---|---|
Run the step again | You can run this step repeatedly without causing harm. |
Skip the step | If you successfully completed the step before, then skip this step. |
Clean up step | None required |
Prepare the node for clustering
If this step fails, click View Results to see the applicable section of the ConfigTrace.log.
About this task
Actions | Notes |
---|---|
Run the step again | You can run this step repeatedly without causing harm. |
Skip the step | If you successfully completed the step before, then skip this step. |
Clean up step | None required |
Complete the cluster setup
About this task
Actions | Notes |
---|---|
Run the step again | You can run this step repeatedly without causing harm. |
Skip the step | If you successfully completed the step before, then skip this step. |
Clean up step | None required |